Your shopping cart is empty!
ASTM International, 01/01/1994
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/01/1994
Pages:11
File Size:1 file , 94 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method describes the determination of the opening Mode I interlaminar fracture toughness, G Ic, of continuous fiber-reinforced composite materials using the double cantilever beam (DCB) specimen (Fig. 1).
1.2 This test method is limited to use with composites consisting of unidirectional carbon fiber and glass fiber tape laminates with brittle and tough single-phase polymer matrices. This limited scope reflects the experience gained in round-robin testing. This test method may prove useful for other types and classes of composite materials; however, certain interferences have been noted (see 6.5).
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard may involve hazardous materials, operations, and equipment.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Ozone-Resistant Thermoplastic Elastomer Insulation For Wire and Cable, 90 degrees C Operation
$25.00 $50.00
Standard Practice for Sample Preparation of Transparent Plastic Films for Specular Gloss Measurements, on Membrane Switch Overlays
$27.00 $54.00
Standard Test Methods for Analysis of Calcium Chloride
$30.00 $60.00
Standard Specification for Contact Molded "Fiberglass" (Glass-Fiber-Reinforced Thermosetting Resin) Flanges