• ASTM D5550-23

ASTM D5550-23

Standard Test Method for Specific Gravity of Soil Solids by Gas Pycnometer

ASTM International, 01/01/2023

Publisher: ASTM

File Format: PDF

$28.00$57.00


Published:01/01/2023

Pages:7

File Size:1 file , 96 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the specific gravity of soil solids by means of a gas pycnometer. Particle size is limited by the dimensions of the test specimen container of the particular pycnometer being used.
1.2 Test Method D854 may be used instead of or in conjunction with this test method for performing specific gravity tests on soils. Note that Test Method D854 does not require the specialized test apparatus needed by this test method. However, Test Method D854 may not be used if the test specimen contains matter that can readily dissolve in water, whereas this test method does not have that limitation.
1.3 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.3.1 For purposes of comparing a measured or calculated value(s) with specified limits, the measured or calculated value(s) shall be rounded to the nearest decimal or significant digits in the specified limits.
1.3.2 The procedures used to specify how data are collected/recorded and calculated in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that should generally be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user''s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.
1.4 Units-The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only and are not considered standard.
1.4.1 The gravitational system of inch-pound units is used when dealing with inch-pound units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs. The converted slug unit is not given, unless dynamic (F = ma) calculations are involved.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM G198-17

ASTM G198-17

Standard Test Method for Determining the Relative Corrosion Performance of Driven Fasteners in Contact with Treated Wood

$24.00 $48.00

ASTM Volume 13.01:2015

ASTM Volume 13.01:2015

ASTM Book of Standards Volume 13.01: Medical Devices, Emergency Medical Services

$121.00 $242.54

ASTM B221M-12

ASTM B221M-12

Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes (Metric)

$33.00 $67.00

ASTM F2408-09

ASTM F2408-09

Standard Specification for Ornamental Fences Employing Galvanized Steel Tubular Pickets

$29.00 $58.00