Your shopping cart is empty!
ASTM International, 04/01/2016
Publisher: ASTM
File Format: PDF
$32.00$65.00
Published:01/04/2016
Pages:19
File Size:1 file , 610 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers the thermal stability of fluids for use in heavy duty manual transmissions when operated at high temperatures.
1.2 The lubricant performance is measured by the number of shifting cycles that can be performed without failure of synchronization when the transmission is operated while continuously cycling between high and low range.
1.3 Correlation of test results with truck transmission service has not been established. However, the procedure has been shown to appropriately separate two transmission lubricants, which have shown satisfactory and unsatisfactory field performance in the trucks of one manufacturer.
1.4 Changes in this test method may be necessary due to refinements in the procedure, obsolescence of parts, or reagents, and so forth. These changes will be incorporated by Information Letters issued by the ASTM Test Monitoring Center (TMC).2 The test method will be revised to show the content of all the letters, as issued.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5.1 Exception-When materials, products, or equipment are available only in inch-pound units, SI units are omitted.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.7 This test method is arranged as follows:
Section
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus
6
Test Transmission
6.2
Transmission Mounts
6.3
Oil-Circulating System
6.4
Oil Return Hole
6.5
Air Pressure Controls
6.6
Drive System
6.7
Instrumentation
6.8
Thermocouple Placement
6.9
Reagents and Materials
7
Safety
8
Preparation of Apparatus
9
Cleaning of Parts
9.1
Assembly
9.2
Calibration
10
Transmission and Test Stand Calibration
10.1
Reference Oils
10.2
Reference Oil Test Frequency
10.3
Instrumentation Calibration
10.4
Shift Time Calibration
10.5
Operating Procedure
Standard Test Methods for Frost Heave and Thaw Weakening Susceptibility of Soils
$33.00 $67.00
Standard Test Methods for Physical Properties of Smooth-Wall, Coilable, Polyethylene (PE) Conduit (Duct) for Preassembled Wire and Cable
$26.00 $52.00
Standard Test Methods for the Determination of the Modulus and Damping Properties of Soils Using the Cyclic Triaxial Apparatus
Standard Test Method for Determining Water Separation Characteristics of Diesel Fuels by Portable Separometer
$30.00 $60.00
