• ASTM D5587-15

ASTM D5587-15

Standard Test Method for Tearing Strength of Fabrics by Trapezoid Procedure

ASTM International, 07/01/2015

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/07/2015

Pages:6

File Size:1 file , 180 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the measurement of the tearing strength of textile fabrics by the trapezoid procedure using a recording constant-rate-of-extension-type (CRE) tensile testing machine.

1.1.1 The CRE-type tensile testing machine has become the preferred test apparatus for determining trapezoid tearing strength. It is recognized that some constant-rate-of-traverse-type (CRT) tensile testing machines continue to be used. Consequently, these test instruments may be used when agreed upon between the purchaser and the supplier. The conditions for use of the CRT-type tensile tester are included in Appendix X1.

1.2 This test method applies to most fabrics including woven fabrics, air bag fabrics, blankets, napped fabrics, knitted fabrics, layered fabrics, pile, and nonwoven fabrics. The fabrics may be untreated, heavily sized, coated, resin-treated, or otherwise treated. Instructions are provided for testing specimens with or without wetting.

1.3 Tearing strength, as measured in this test method, requires that the tear be initiated before testing. The reported value obtained is not directly related to the force required to initiate or start a tear.

1.4 Two calculations for trapezoid tearing strength are provided: the single-peak force and the average of five highest peak forces.

1.5 The values stated in SI units are to be regarded as the standard. The values stated in inch-pound units may be approximate.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM D396-15c

ASTM D396-15c

Standard Specification for Fuel Oils

$33.00 $67.00

ASTM D7786-12

ASTM D7786-12

Standard Test Method for Determining Enamel Holdout

$25.00 $50.00

ASTM D6477-13e1

ASTM D6477-13e1

Standard Terminology Relating to Tire Cord, Bead Wire, Hose Reinforcing Wire, and Fabrics (Withdrawn 2022)

$32.00 $64.00

ASTM B750-99e1

ASTM B750-99e1

Standard Specification for Zinc-5% Aluminum-Mischmetal Alloy in Ingot Form for Hot-Dip Coatings

$25.00 $50.00