• ASTM D56-00

ASTM D56-00

Standard Test Method for Flash Point by Tag Closed Tester

ASTM International, 08/10/2000

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:10/08/2000

Pages:11

File Size:1 file , 110 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of the flash point, by tag manual and automated closed testers, of liquids with a viscosity below 5.5 mm²/s (cSt) at 40oC (104oF), or below 9.5 mm²/s (cSt) at 25oC (77oF), and a flash point below 93oC (200oF).

1.1.1 For the closed-cup flash point of liquids with the following properties: a viscosity of 5.5 mm²/s (cSt) or more at 40oC (104oF); a viscosity of 9.5 mm²/s (cSt) or more at 25oC (77oF); a flash point of 93oC (200oF) or higher; a tendency to form a surface film under test conditions; or containing suspended solids, Test Method D93 can be used.

1.1.2 For cut-back asphalts refer to Test Methods D1310 and D3143.

Note 1--The U.S. Department of Transportation (RSTA) and U.S. Department of Labor (OSHA) have established that liquids with a flash point under 37.8oC (100oF) are flammable as determined by this test method for those liquids that have a viscosity less than 5.5 mm²/s (cSt) at 40oC (104oF) or 9.5 mm²/s (cSt) or less at 25oC (77oF), or do not contain suspended solids or do not have a tendency to form a surface film while under test. Other flash point classifications have been established by these departments for liquids using this test method.

1.2 This test method can be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and cannot be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test method can be used as elements of fire risk assessment that takes into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.

1.3 Related Standards are Test Methods D93, D1310, D3828, D3278, and D3941.

1.4 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see 8.2 and 8.3 and and refer to Material Safety Data Sheets.

More ASTM standard pdf

ASTM D4550-98

ASTM D4550-98

Standard Specification for Thermoplastic Elastomer-Ether-Ester (TEEE) (Withdrawn 2004)

$29.00 $58.00

ASTM B415-98(2002)

ASTM B415-98(2002)

Standard Specification for Hard-Drawn Aluminum-Clad Steel Wire

$26.00 $52.00

ASTM D6237-98

ASTM D6237-98

Standard Guide for Painting Inspectors (Concrete and Masonry Substrates)

$32.00 $65.00

ASTM E1398-91(1998)

ASTM E1398-91(1998)

Standard Practice for the in vivo Rat Hepatocyte DNA Repair Assay

$29.00 $58.00