• ASTM D5600-17

ASTM D5600-17

Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES)

ASTM International, 05/01/2017

Publisher: ASTM

File Format: PDF

$34.00$68.00


Published:01/05/2017

Pages:5

File Size:1 file , 84 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the analysis for commonly determined trace metals in test specimens of raw and calcined petroleum coke by inductively coupled plasma atomic emission spectroscopy.

1.2 Elements for which this test method is applicable are listed in Table 1. Detection limits, sensitivity, and optimum ranges of the metals will vary with the matrices and model of spectrometer.

(A) The wavelengths listed were utilized in the round robin because of their sensitivity. Other wavelengths can be substituted if they can provide the needed sensitivity and are treated with the same corrective techniques for spectral interference (see 6.1). In time, other elements may be added as more information becomes available and as required.
(B) Alternative wavelengths can be found in references such as “Inductively Coupled Plasma Atomic Emission Spectroscopy,” Winge, R. K., Fassel, V. A., Peterson, V. J., and Floyd, M. A., Elsevier, 1985.
(C) Based on this round-robin study. This test method can be applicable to other elements or concentration ranges but precision data is not available.

1.3 This test method is applicable only to samples containing less than one mass % ash.

1.4 Elements present at concentrations above the upper limit of the working ranges can be determined with additional, appropriate dilutions.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C1036-11

ASTM C1036-11

Standard Specification for Flat Glass

$30.00 $60.00

ASTM F2068-00

ASTM F2068-00

Standard Specification for Femoral Prostheses - ;Metallic Implants

$29.00 $58.00

ASTM C1766-15

ASTM C1766-15

Standard Specification for Factory-Laminated Gypsum Panel Products

$26.00 $52.00

ASTM D661-93

ASTM D661-93

Standard Test Method for Evaluating Degree of Cracking of Exterior Paints

$26.00 $52.00