• ASTM D5800-21

ASTM D5800-21

Standard Test Method for Evaporation Loss of Lubricating Oils by the Noack Method

ASTM International, 10/01/2021

Publisher: ASTM

File Format: PDF

$39.00$78.00


Published:01/10/2021

Pages:25

File Size:1 file , 1 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This test method covers four procedures for determining the evaporation loss of lubricating oils (particularly engine oils). The evaporation measured is reported as percent total loss. The test method relates to one set of operating conditions but may be readily adapted to other conditions as required.

1.2''Procedure B and Procedure D that are in the main section of the test method provide equivalent results. Procedures A and C, which are in Annex A1 and Annex A2, have equivalent results. It has been determined that Procedures A and C show a slight bias when compared to Procedures B and D. Procedures B and D give slightly higher results versus Procedures A and C on formulated engine oils, while Procedures B and D give lower results versus Procedures A and C on basestocks. Thus, a correction factor is utilized to convert between the two sets of Procedures based on the fluid type.

1.3''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C336-71(2020)

ASTM C336-71(2020)

Standard Test Method for Annealing Point and Strain Point of Glass by Fiber Elongation

$25.00 $50.00

ASTM Volume 06.03:2020

ASTM Volume 06.03:2020

ASTM Book of Standards Volume 06.03 Paint -- Pigments, Polymers, Resins, Naval Stores, Cellulosic Esters, and Ink Vehicles

$109.00 $219.02

ASTM D1909-13(2020)

ASTM D1909-13(2020)

Standard Tables of Commercial Moisture Regains and Commercial Allowances for Textile Fibers

$26.00 $52.00

ASTM D7415-21

ASTM D7415-21

Standard Test Method for Condition Monitoring of Sulfate By-Products in In-Service Petroleum and Hydrocarbon Based Lubricants by Trend Analysis Using Fourier Transform Infrared (FT-IR) Spectrometry

$34.00 $68.00