• ASTM D5819-05(2012)

ASTM D5819-05(2012)

Standard Guide for Selecting Test Methods for Experimental Evaluation of Geosynthetic Durability

ASTM International, 07/01/2012

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/07/2012

Pages:11

File Size:1 file , 130 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This guide covers a designer/specifier through a systematic determination of those factors of the appropriate application environment that may affect the post-construction service life of a geosynthetic. Subsequently, test methods are recommended to facilitate an experimental evaluation of the durability of geosynthetics in a specified environment so that the durability can be considered in the design process.

TABLE 1 FunctionsA and Other Performance CharacteristicsB

ContainmentB (C)-A geosynthetic provides containment when it encapsulates or surrounds materials such as sand, rocks, and fresh concrete.C

FiltrationA (F)-A geosynthetic performs the filtration function when the equilibrium geotextile-to-soil system allows for adequate liquid flow with limited soil loss across the plane of the geotextile over a service lifetime compatible with the application under consideration.

Fluid BarrierA (FB)-A geosynthetic performs the fluid barrier function when it essentially eliminates the migration of fluids through it.

Fluid TransmissionA (a.k.a. drainage)-A geosynthetic performs the fluid transmission function when the equilibrium geotextile-to-soil system allows for adequate flow with limited soil loss within the plane of the geotextile over a service lifetime compatible with the application under consideration.

InsulationB (I)-A geosynthetic provides insulation when it reduces the passage of heat, electricity, or sound.

ProtectionA (P)-A geosynthetic, placed between two materials, performs the protection function when it alleviates or distributes stresses and strains transmitted to the material to be protected.

ReinforcementA (R)-A geosynthetic performs the reinforcement function when it provides often synergistic improvement of a total system's strength created by the introduction of a tensile force into a soil (good in compression but poor in tension) or other disjointed and separated material.

ScreeningB (Scr)-A geosynthetic, placed across the path of a flowing fluid (ground water, surface water, wind) carrying particles in suspension, provides screening when it retains some or all soil fine particles while allowing the fluid to pass through. After some period of time, particles accumulate against the screen which requires that the screen be able to withstand pressures generated by the accumulated particles and the increasing fluid pressure.

SeparationA (S)-A geosynthetic placed between dissimilar materials so that the integrity and functioning of both materials can remain intact or be improved performs the separation function.

Surface StabilizationB (SS)-A geosynthetic, placed on a soil surface, provides surface stabilization when it restricts movement and prevents dispersion of surface soil particles subjected to erosion actions (rain, wind), often while allowing or promoting vegetative growth.

Vegetative ReinforcementB (VR)-A geosynthetic provides vegetative reinforcement when it extends the erosion control limits and performance of vegetation.

More ASTM standard pdf

ASTM D5887-09

ASTM D5887-09

Standard Test Method for Measurement of Index Flux Through Saturated Geosynthetic Clay Liner Specimens Using a Flexible Wall Permeameter

$30.00 $60.00

ASTM B134/B134M-08

ASTM B134/B134M-08

Standard Specification for Brass Wire

$30.00 $60.00

ASTM G77-98

ASTM G77-98

Standard Test Method for Ranking Resistance of Materials to Sliding Wear Using Block-on-Ring Wear Test

$32.00 $65.00

ASTM F1920-98

ASTM F1920-98

Standard Test Method for Energy Performance of Rack Conveyor, Hot Water Sanitizing, Commercial Dishwashing Machines

$32.00 $65.00