• ASTM D5875/D5875M-18

ASTM D5875/D5875M-18

Standard Guide for Use of Cable-Tool Drilling and Sampling Methods for Geoenvironmental Exploration and Installation of Subsurface Water Quality Monitoring Devices

ASTM International, 06/01/2018

Publisher: ASTM

File Format: PDF

$24.00$48.00


Published:01/06/2018

Pages:8

File Size:1 file , 480 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This guide covers cable-tool drilling and sampling procedures used for geoenvironmental exploration and installation of subsurface water quality monitoring devices.

1.2 Several sampling methods exist for obtaining samples from drill holes for geoenvironmental purposes and subsequent laboratory testing. Selection of a particular drilling procedure should be made on the basis of sample types needed and geohydrologic conditions observed at the study site.

1.3 Drilling procedures for geoenvironmental exploration often will involve safety planning, administration and documentation. This guide does not purport to specifically address exploration and site safety.

Note 1: This guide does not include considerations for geotechnical site characterizations.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This guide offers an organized collection of information or a series of options and does not recommend a specific course of action. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this guide may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word “Standard” in the title of this document means only that the document has been approved through the ASTM consensus process.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM B924-02(2006)

ASTM B924-02(2006)

Standard Specification for Seamless and Welded Nickel Alloy Condenser and Heat Exchanger Tubes With Integral Fins

$30.00 $60.00

ASTM D6-95(2006)

ASTM D6-95(2006)

Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds

$26.00 $52.00

ASTM D6221-00(2006)

ASTM D6221-00(2006)

Standard Specification for Reinforced Bituminous Flashing Sheets for Roofing and Waterproofing

$26.00 $52.00

ASTM F1827-97(2006)

ASTM F1827-97(2006)

Standard Terminology Relating to Food Service Equipment

$29.00 $58.00