1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.
1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see and ). Note 1There is no equivalent ISO standard.
1.3 Order of PrecedenceIn the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
1.4 The values stated in SI units are to be considered standard.
More ASTM standard pdf
ASTM D4607-94(2011)
Standard Test Method for Determination of Iodine Number of Activated Carbon
$30.00 $60.00
ASTM D7315-17
Standard Test Method for Determination of Turbidity Above 1 Turbidity Unit (TU) in Static Mode
$37.00 $75.00
ASTM D2665-04a
Standard Specification for Poly(Vinyl Chloride) (PVC) Plastic Drain, Waste, and Vent Pipe and Fittings
$30.00 $60.00
ASTM C932-98a
Standard Specification for Surface-Applied Bonding Agents for Exterior Plastering
$31.00 $62.00