Your shopping cart is empty!
ASTM International, 10/01/2012
Publisher: ASTM
File Format: PDF
$34.00$69.00
Published:01/10/2012
Pages:11
File Size:1 file , 160 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.
1.2 Classification - Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).
Resin
Phenolic, cellulose filled
Phenolic, mineral/glass filled
Melamine
Polyester
Diallyl iso-phthalate
Diallyl ortho-phthalate
Silicone
Epoxy
1.3 Order of Precedence - In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
1.4 The values stated in SI units are to be considered standard.
Standard Test Method for Wind Resistance of Sealed Asphalt Shingles (Uplift Force/Uplift Resistance Method)
$33.00 $67.00
Test Method for Tensile Properties of Fiber Reinforced Metal Matrix Composites
$29.00 $58.00
Standard Specification for Cautionary Labeling of Portable Kerosine and Diesel Containers for Consumer Use
$25.00 $50.00
Standard Test Method for Color of Cresylic Acids ("C" Series Standards)
