1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.
1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).
Note 1 - There is no equivalent ISO standard.
1.3 Order of PrecedenceIn the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
1.4 The values stated in SI units are to be considered standard.
More ASTM standard pdf
ASTM D3855-84(2000)
Standard Test Method for Rubber Thread-Deterioration Due to Standard Washing Solution Treatment
$25.00 $50.00
ASTM D5442-17
Standard Test Method for Analysis of Petroleum Waxes by Gas Chromatography
$32.00 $64.00
ASTM F1506-15
Standard Performance Specification for Flame Resistant and Arc Rated Textile Materials for Wearing Apparel for Use by Electrical Workers Exposed to Momentary Electric Arc and Related Thermal Hazards
$29.00 $58.00