Your shopping cart is empty!
ASTM International, 05/01/2017
Publisher: ASTM
File Format: PDF
$43.00$86.00
Published:01/05/2017
Pages:22
File Size:1 file , 450 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including viscosity increase and soot concentrations (loading).2 This test method is commonly referred to as the Mack T-8.
1.2 This test method also provides the procedure for running an extended length T-8 test, which is commonly referred to as the T-8E and an abbreviated length test, which is commonly referred to as T-8A. The procedures for the T-8E and the T-8A are identical to the T-8 with the exception of the items specifically listed in Annex A8 and Annex A9 respectively. Additionally, the procedure modifications listed in Annex A8 and Annex A9 refer to the corresponding section of the T-8 procedure.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1 Exceptions-Where there is no direct SI equivalent such as the units for screw threads, National Pipe Threads/diameters, tubing size, sole source equipment suppliers, and oil consumption in grams per kilowatt-hour.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Annex A6 for specific safety precautions.
1.5 A Table of Contents follows:
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus
6
General Description
6.1
The Test Engine
6.2
Mack Test Engine
6.2.1
Engine Cooling System
6.2.2
Engine Oil System
6.2.3
Auxiliary Oil System
6.2.4
Crankcase Aspiration
6.2.5
Blowby Meter
6.2.6
Air Supply and Filtration
6.2.7
Fuel Supply
6.2.8
Intake Manifold Temperature Control
6.2.9
Engine Fluids
7
Test Oil
7.1
Test Fuel
7.2
Engine Coolant
7.3
Cleaning Materials
7.4
Preparation of Apparatus at Rebuild
8
Cleaning of Parts
8.1
Valves, Seats, Guides, and Springs
8.2
Cylinder Liner, Piston, and Piston Ring Assembly
8.3
Injectors and Injection Pump
Standard Guide for Testing Systems for Measuring Dynamic Responses of Carbon Monoxide Detectors to Gases and Vapors
$26.00 $52.00
Standard Test Method for Length Change Calibration of Thermomechanical Analyzers
$34.00 $68.00
Standard Practice for Conducting Ruggedness Tests
$32.00 $65.00
Standard Consumer Safety Specification for Infant Swings
$33.00 $67.00
