Your shopping cart is empty!
ASTM International, 11/01/2007
Publisher: ASTM
File Format: PDF
$26.00$52.00
Published:01/11/2007
Pages:3
File Size:1 file , 77 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method explains the determination of the ability of Controlled Low Strength Material (CLSM) to withstand loading by repeatedly dropping a metal weight onto the in-place material.
1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.
1.2.1 The method used to specify how data are collected, calculated, or recorded in this test method is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.
1.3 The values stated in SI units are to be regarded as the standard. The inch-pound equivalents are shown for information only.
1.4 CLSM is also known as flowable fill, controlled density fill, soil-cement slurry, soil-cement grout, unshrinkable fill, "K-Krete," and other similar names.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ( Warning: Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)
Standard Methods for Chemical Analysis of Chromium and Ferrochromium
$27.00 $54.00
Standard Specification for Low-Alloy Steel Deformed and Plain Bars for Concrete Reinforcement
$30.00 $60.00
Standard Specification for Metallic Mechanical Fittings for Use on Outside Diameter Controlled Thermoplastic Gas Distribution Pipe and Tubing
Methods for Detection and Enumeration of Microbiological Contaminants in Water Used for Processing Electron and Microelectronic Devices
$106.00 $213.01