Your shopping cart is empty!
ASTM International, 07/01/2015
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/07/2015
Pages:4
File Size:1 file , 91 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method explains the determination of the ability of Controlled Low Strength Material (CLSM) to withstand loading by repeatedly dropping a metal weight onto the in-place material.
1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.2.1 The procedures used to specify how data are collected/recorded and calculated in the standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user's objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyond the scope of these test methods to consider significant digits used in analysis methods for engineering data.
1.3 Units-The values stated in either SI units or inch-pound units presented in brackets are to be regarded separately as standard. The values stated in each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 CLSM is also known as flowable fill, controlled density fill, soil-cement slurry, soil-cement grout, unshrinkable fill, “K-Krete,” and other similar names.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning-Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2)
Standard Test Method for Rubber Property-Effect of Liquids
$32.00 $65.00
Standard Test Method for Cathodic Disbonding of Pipeline Coatings Subjected to Elevated Temperatures
$29.00 $58.00
Standard Test Methods for Particle Size (Sieve Analysis) of Plastic Materials
$30.00 $60.00
Standard Specification for Heavy Vehicular Paving Brick
$26.00 $52.00
