• ASTM D6034-17

ASTM D6034-17

Standard Test Method (Analytical Procedure) for Determining the Efficiency of a Production Well in a Confined Aquifer from a Constant Rate Pumping Test

ASTM International, 01/01/2017

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/01/2017

Pages:8

File Size:1 file , 250 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method describes an analytical procedure for determining the hydraulic efficiency of a production well in a confined aquifer. It involves comparing the actual drawdown in the well to the theoretical minimum drawdown achievable and is based upon data and aquifer coefficients obtained from a constant rate pumping test.

1.2 This analytical procedure is used in conjunction with the field procedure, Test Method D4050.

1.3 The values stated in inch-pound units are to be regarded as standard, except as noted below. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.

1.3.1 The gravitational system of inch-pound units is used when dealing with inch-pound units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs.

1.4 Limitations-The limitations of the technique for determination of well efficiency are related primarily to the correspondence between the field situation and the simplifying assumption of this test method.

1.5 All observed and calculated values shall conform to the guidelines for significant digits and round established in Practice D6026, unless superseded by this standard.

1.5.1 The procedures used to specify how data are collected/recorded or calculated, in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user's objectives; and it is common practice to increase or reduce significant digits of reported date to be commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis method for engineering design.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM B86-10

ASTM B86-10

Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloy Foundry and Die Castings

$30.00 $60.00

ASTM D5034-09

ASTM D5034-09

Standard Test Method for Breaking Strength and Elongation of Textile Fabrics (Grab Test)

$30.00 $60.00

ASTM A982/A982M-05(2010)

ASTM A982/A982M-05(2010)

Standard Specification for Steel Forgings, Stainless, for Compressor and Turbine Airfoils

$26.00 $52.00

ASTM D4175-09

ASTM D4175-09

Standard Terminology Relating to Petroleum, Petroleum Products, and Lubricants

$48.00 $97.00