Your shopping cart is empty!
ASTM International, 01/01/1996
Publisher: ASTM
File Format: PDF
$25.00$50.00
Published:01/01/1996
Pages:3
File Size:1 file , 21 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method describes the procedure for determining the relative setting speed of heatset inks using a specific tester.
1.2 this test method is applicable to printing inks intended to be dried by the application of heat and for which a suitable reference standard is available.
1.3 Although heatset inks are normally printed by the offset process, this test method specifies the direct letterpress mode because the higher ink film thicknesses obtained tend to amplify subtle differences in ink setting speed.
1.4 This tester reads temperature and belt speed in nonmetric terms; therefore, instrument settings in this test method are stated first in U.S. Customary Units (inch-pound units of measurements). The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for General Purpose Wirebound Shipping Boxes
$33.00 $67.00
Standard Test Method for Laboratory Evaluation of Magnesium Sacrificial Anode Test Specimens for Underground Applications
$34.00 $68.00
Standard Test Method for Determining Transmissivity of Nonleaky Confined Aquifers by the Theis Recovery Method
$24.00 $48.00
Standard Test Method for Dynamic Young's Modulus, Shear Modulus, and Poisson's Ratio by Impulse Excitation of Vibration
$32.00 $65.00