• ASTM D6121-11

ASTM D6121-11

Standard Test Method for Evaluation of Load-Carrying Capacity of Lubricants Under Conditions of Low Speed and High Torque Used for Final Hypoid Drive Axles

ASTM International, 10/01/2011

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/10/2011

Pages:18

File Size:1 file , 270 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method is commonly referred to as the L-37 test. This test method covers a test procedure for evaluating the load-carrying, wear, and extreme pressure properties of a gear lubricant in a hypoid axle under conditions of low-speed, high-torque operation.

1.2 This test method also provides for the running of the low axle temperature (Canadian) L-37 test. The procedure for the low axle temperature (Canadian) L-37 test is identical to the standard L-37 test with the exceptions of the items specifically listed in Annex A6. The procedure modifications listed in Annex A6 refer to the corresponding section of the standard L-37 test method.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3.1 Exceptions-In Table A9.1, the values stated in SI units are to be regarded as standard. Also, no SI unit is provided where there is not a direct SI equivalent.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning information is given in Sections 4 and 7.

More ASTM standard pdf

ASTM C544-03

ASTM C544-03

Standard Test Method for Hydration of Dead Burned Magnesite or Periclase Grain

$26.00 $52.00

ASTM E2321-03

ASTM E2321-03

Standard Practice for Use of Test Methods E 96 for Determining the Water Vapor Transmission (WVT) of Exterior Insulation and Finish Systems (EIFS)

$25.00 $50.00

ASTM E740-03

ASTM E740-03

Standard Practice for Fracture Testing with Surface-Crack Tension Specimens

$30.00 $60.00

ASTM E766-98(2003)

ASTM E766-98(2003)

Standard Practice for Calibrating the Magnification of a Scanning Electron Microscope

$30.00 $60.00