• ASTM D6154-15(2021)e1

ASTM D6154-15(2021)e1

Standard Specification for Chemically Modified Asphalt Cement for Use in Pavement Construction

ASTM International, 12/15/2021

Publisher: ASTM

File Format: PDF

$24.00$48.00


Published:15/12/2021

Pages:2

File Size:1 file , 65 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This specification covers asphalt cements that have been modified by the addition of a chemical gellant. It was developed to provide a reference for specifying chemically modified asphalt cement and reflects the properties of currently available commercial products. The tests are intended to measure degree of modification, not performance characteristics. This is not intended to be a performance-based specification.

1.2''Chemically modified asphalt cements are normally produced by addition of a chemical stabilizer. However, any asphalt modifier may be used that will give the required test results when blended with the desired asphalt.

1.3''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4''The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.5''The following precautionary statement pertains to the test method portion only, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F1807-11ae1

ASTM F1807-11ae1

Standard Specification for Metal Insert Fittings Utilizing a Copper Crimp Ring for SDR9 Cross-linked Polyethylene (PEX) Tubing and SDR9 Polyethylene of Raised Temperature (PE-RT) Tubing

$29.00 $58.00

ASTM F996-98

ASTM F996-98

Standard Test Method for Separating an Ionizing Radiation-Induced MOSFET Threshold Voltage Shift Into Components Due to Oxide Trapped Holes and Interface States Using the Subthreshold Current-Voltage Characteristics

$31.00 $62.00

ASTM F1832-07(2011)

ASTM F1832-07(2011)

Standard Test Method for Determining the Force-Draw and Let-Down Curves for Archery Bows

$25.00 $50.00

ASTM F1960-14a

ASTM F1960-14a

Standard Specification for Cold Expansion Fittings with PEX Reinforcing Rings for Use with Cross-linked Polyethylene (PEX) Tubing

$29.00 $58.00