Your shopping cart is empty!
ASTM International, 12/01/2018
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/12/2018
Pages:8
File Size:1 file , 160 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers procedures concerning site preparation, technical procedures, quality control, and equipment to direct the efforts for determining volumes of bulk material. These procedures include practical and accepted methods of volumetric determination.
1.2 This test method allows for only two volume computation methods.
1.2.1 Contour Test Method-See 8.1.1 and 9.1.
1.2.2 Cross-Section Test Method-See 8.1.2 and 9.2.
1.2.3 This test method requires direct operator compilation for both contours and cross-section development.
1.2.4 The use of Digital Terrain Model software and procedures to create contours or cross sections for volume calculation is NOT encompassed in this test method.
Note 1: A task group has been established to develop a test method for Digital Terrain Modeling (DTM) procedures. It will address all known data collection procedures such as conventional ground survey, photogrammetry, geodetic positioning satellite (GPS), and so forth.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Classification System and Basis for Specification for Cellulose Acetate Butyrate Molding and Extrusion Compounds (CAB)
$28.00 $57.00
Standard Practice for Guided Wave Testing of Above Ground Steel Piping with Magnetostrictive Transduction
$31.00 $63.00
Standard Test Method for Measurement of Fatigue Crack Growth Rates
$53.00 $107.00
Standard Specification for Arc Rated Eye or Face Protective Products
$38.00 $76.00
