• ASTM D6176-97(2022)

ASTM D6176-97(2022)

Standard Practice for Measuring Surface Atmospheric Temperature with Electrical Resistance Temperature Sensors

ASTM International, 03/01/2022

Publisher: ASTM

File Format: PDF

$27.00$54.00


Published:01/03/2022

Pages:5

File Size:1 file , 85 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1''This practice provides procedures to measure representative near-surface atmospheric (outdoor air) temperature for meteorological purposes using commonly available electrical thermometers housed in radiation shields mounted on stationary or portable masts or towers.

1.2''This practice is applicable for measurements over the temperature range normally encountered in the ambient atmosphere, '''50 to +50'''''C.

1.3''Air temperature measurement systems include a radiation shield, resistance thermometer, signal cables, and associated electronics.

1.4''Measurements can be made at a single level for various meteorological purposes, at two or more levels for vertical temperature differences, and using special equipment (at one or more levels) for fluctuations of temperature with time applied to flux or variance measurements.

1.5''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C1511-15

ASTM C1511-15

Standard Test Method for Determining the Water Retention (Repellency) Characteristics of Fibrous Glass Insulation (Aircraft Type)

$28.00 $56.00

ASTM D3747-79(2007)

ASTM D3747-79(2007)

Standard Specification for Emulsified Asphalt Adhesive for Adhering Roof Insulation (Withdrawn 2016)

$26.00 $52.00

ASTM D92-05a(2010)

ASTM D92-05a(2010)

Standard Test Method for Flash and Fire Points by Cleveland Open Cup Tester

$30.00 $60.00

ASTM D2961/D2961M-18

ASTM D2961/D2961M-18

Standard Test Method for Single-Stage Total Moisture Less than 15 % in Coal Reduced to 2.36 mm [No. 8 Sieve] Topsize

$25.00 $50.00