• ASTM D619-14

ASTM D619-14

Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation

ASTM International, 11/01/2014

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/11/2014

Pages:8

File Size:1 file , 120 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.

1.2 The procedures appear in the following sections:

Procedure   

Section

   Arc resistance

23

   Ash

6

   Bond strength (ply adhesion)

16

   Bursting strength

14

   Compressive strength

12, 25, 30

   Conditioning

4

   Density

17, 26, 32

   Dielectric strength

18, 27

   Dimensional measurements

28, 33

   Flammability

22

   Flexural strength

13, 31

   Silica

7

   Tearing strength

11

   Tensile strength

10, 24, 29

   Thickness (sheets)

20

   Resistance to impact

15

   Rockwell hardness

19

   Volatile matter

8

   Water absorption

5

   Zinc chloride

9

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.3, 22.1, 22.2.

Note 1: The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures. Conduct comparative tests if necessary before directly comparing results of tests using the different procedures.

More ASTM standard pdf

ASTM D6437-05(2010)e1

ASTM D6437-05(2010)e1

Standard Test Method for Polyurethane Raw Materials: alkalinity in Low-Alkalinity Polyols (Determination of CPR values of Polyols)

$26.00 $52.00

ASTM B824-16

ASTM B824-16

Standard Specification for General Requirements for Copper Alloy Castings

$29.00 $58.00

ASTM D1793-17

ASTM D1793-17

Standard Test Method for Water Spotting of Emulsion Floor Polishes

$21.00 $42.00

ASTM D1640/D1640M-14(2018)

ASTM D1640/D1640M-14(2018)

Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings

$28.00 $56.00