• ASTM D6272-00

ASTM D6272-00

Standard Test Method for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials by Four-Point Bending

ASTM International, 01/01/2000

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/01/2000

Pages:8

File Size:1 file , 64 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of flexural properties of unreinforced and reinforced plastics, including high-modulus composites and electrical insulating materials in the form of rectangular bars molded directly or cut from sheets, plates, or molded shapes. These test methods are generally applicable to rigid and semirigid materials. However, flexural strength cannot be determined for those materials that do not break or that do not fail in the outer fibers. This test method utilizes a four point loading system applied to a simply supported beam.

1.2 This test method may be used with two procedures:

1.2.1 Procedure A, designed principally for materials that break at comparatively small deflections.

1.2.2 Procedure B, designed particularly for those materials that undergo large deflections during testing.

1.2.3 Procedure A shall be used for measurement of flexural properties, particularly flexural modulus, unless the material specification states otherwise. Procedure B may be used for measurement of flexural strength.

1.3 Comparative tests may be run according to either procedure, provided that the procedure is found satisfactory for the material being tested.

1.4 The values stated in SI units are to be regarded as the standard. The values provided in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1 - This test method is equivalent to, but not identical to ISO 14125 (Method B).

More ASTM standard pdf

ASTM F109-91(1996)

ASTM F109-91(1996)

Standard Terminology Relating to Surface Imperfections on Ceramics

$25.00 $50.00

ASTM C761-96

ASTM C761-96

Standard Test Methods for Chemical, Mass Spectrometric, Spectrochemical, Nuclear, and Radiochemical Analysis of Uranium Hexafluoride

$41.00 $83.00

ASTM F1097-91(1996)

ASTM F1097-91(1996)

Standard Specification for Mortar, Refractory (High-Temperature, Air-Setting)

$25.00 $50.00

ASTM F471-76(1996)

ASTM F471-76(1996)

Standard Terminology Relating to Combination Locks

$25.00 $50.00