Your shopping cart is empty!
ASTM International, 04/01/2016
Publisher: ASTM
File Format: PDF
$24.00$48.00
Published:01/04/2016
Pages:8
File Size:1 file , 310 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 These test methods determine and report the hiding power of a powder coating with respect to two parameters:
1.1.1 Test Method A-Contrast Ratio at a given film thickness
1.1.2 Test Method B-Film thickness at 0.98 (98 %) contrast ratio.
Note 1: The measured parameters follow powder coating industry practice by measuring hiding power in relation to film thickness, rather than the “Spreading Rate” function employed in Test Methods D344 and D2805 and other hiding power test methods.
Note 2: Hiding power is photometrically defined as the spreading rate at 0.98 contrast ratio. See definitions of spreading rate and hiding power in Terminology D16, D2805, and the Paint and Coatings Testing Manual.
Note 3: The contrast ratio 0.98 is conventionally accepted in the coatings industry as representing “complete” hiding for reflectometric hiding power measurements. But visually, as well as photometrically, it is slightly less than complete.
1.2 These test methods cover the determination of the hiding power of powder coatings applied by electrostatic spraying.
1.3 These test methods determine hiding power by means of reflectometric and thickness gage measurements. They are limited to coatings having a minimum CIE-Y reflectance of 15 %.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and to determine in advance the applicability of regulatory limitations prior to use.
Standard Test Method for Determination of Dynamic Viscosity and Derived Kinematic Viscosity of Liquids by Oscillating Piston Viscometer
$29.00 $58.00
Standard Test Method for Measuring Mass per Unit Area of Geotextiles
$26.00 $52.00
Standard Test Methods for Working, Initial Setting, and Service Strength Setting Times of Chemical-Resistant Resin Mortars
$25.00 $50.00
Standard Test Method for Endurance (Wear) Life and Load-Carrying Capacity of Solid Film Lubricants (Falex Pin and Vee Method)
$30.00 $60.00
