• Your shopping cart is empty!

  • ASTM D6483-99

ASTM D6483-99

Standard Test Method for Evaluation of Diesel Engine Oils in T-9 Diesel Engine

ASTM International, 12/10/1999

Publisher: ASTM

File Format: PDF

$45.00$91.00


Published:10/12/1999

Pages:48

File Size:1 file , 4.4 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method is commonly referred to as the Mack T-9. This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including lead corrosion and wear of piston rings and cylinder liners.

1.2 The values stated in either SI or inch-pound units are to be regarded separately as the standard. Within the test method, the inch-pound units are shown in parentheses when combined with SI units.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See for specific safety precautions.

1.4 Table of Contents

Scope Referenced Documents Terminology Summary of Test Method Significance of Use Apparatus General Description Test Engine Mack T-9 Test Engine Engine Cooling System Engine Oil System Auxiliary Oil System Blowby Meter Air Supply and Filtration Fuel Supply Intake Manifold Temperature Control Engine Fluids Test Oil Test Fuel Engine Coolant Cleaning Materials Preparation of Apparatus at Rebuild Cleaning of Parts Valves, Seats, Guides, and Springs Cylinder Liner, Piston, and Piston Ring Assembly Injectors and Injection Pump Assembly Instructions Measurements System Time Responses Procedure Pretest Procedure Engine Start-Up Engine Shutdown Test Cycle Oil Addition/Drain Oil Samples Oil Consumption Calculations Fuel Samples Periodic Measurements Blowby Centrifugal Oil Filter Mass Gain Oil Filter P Calculation Inspection of Engine, Fuel, and Oil Pre-Test Measurements Post-Test Measurements Oil Inspection Fuel Inspections Oil Consumption Laboratory and Engine Test Stand Calibration/Non-Reference Requirements Calibration Frequency Calibration Reference Oils Test Numbering New Laboratories and New Test Stands Test Stand and Engine Calibration Test Results Reference and Non-Reference Oil Test Requirements Non-Reference Oil Test Result Severity Adjustments Report Reporting Reference Test Results Deviations from Test Operational Limits Electronic Transmission of Test Results Precision and Bias Precision Bias Keywords Annexes Report Forms Sensor Locations Procurement of Test Materials Instructions for Measuring T-9 Cylinder Sleeves Using the Taylor Hobson Form Talysurf Safety Precautions Data Dictionary TBN Measurement Procedure for T-9 Samples TAN Measurement Procedure for T-9 Samples Determination of Operational Validity

More ASTM standard pdf

ASTM D4734-20

ASTM D4734-20

Standard Specification for Refined Benzene-545

$22.00 $44.00

ASTM D6763-16

ASTM D6763-16

Standard Guide for Testing Exterior Wood Stains and Clear Water Repellents

$34.00 $68.00

ASTM E815-17a

ASTM E815-17a

Standard Test Method for Determination of Calcium Fluoride in Fluorspar by EDTA Complexometric Titrimetry

$25.00 $50.00

ASTM D6299-20

ASTM D6299-20

Standard Practice for Applying Statistical Quality Assurance and Control Charting Techniques to Evaluate Analytical Measurement System Performance

$44.00 $89.00