Your shopping cart is empty!
ASTM International, 10/01/2016
Publisher: ASTM
File Format: PDF
$49.00$98.00
Published:01/10/2016
Pages:76
File Size:1 file , 2.5 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers and is commonly referred to as the Sequence VG test,2 and it has been correlated with vehicles used in stop-and-go service prior to 1996, particularly with regard to sludge and varnish formation.3 It is one of the test methods required to evaluate oils intended to satisfy the API SL performance category.
1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.2.1 Exception-Where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, tubing size, or specified single source equipment.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.7, 7.10.2.2, 8.3.4.2, 8.4.4.3, 9.2.6, 9.3.4.5, 12.1.1.7, 12.2.1.4, and Annex A5.
1.4 A Table of Contents follows:
Section
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus (General Description)
6
Apparatus (The Test Engine)
7
Sequence VG Test Engine
7.1
Required New Engine Parts
7.2
Reusable Engine Parts
7.3
Specially Fabricated Engine Parts
7.4
Special Engine Measurement and Assembly Equipment
7.5
Miscellaneous Engine Components-Preparation
7.6
Solvents and Cleaners Required
7.7
Assembling the Test Engine-Preparations
7.8
Assembling the Test Engine-Installations
7.9
Engine Installation on the Test Stand
7.10
Engine Fluids (Supply/Discharge Systems)
8
Intake Air
8.1
Fuel and Fuel System
8.2
Engine Oil and Engine Oil System
8.3
Standard Practice for Mixing Thermal Insulating Cement Samples
$26.00 $52.00
Standard Specification for Intramedullary Reamers
$25.00 $50.00
Standard Specification for Metal Insert Fittings Utilizing a Copper Crimp Ring for SDR9 Cross-linked Polyethylene (PEX) Tubing and SDR9 Cross-linked Polyethylene/Aluminum/Cross-linked Polyethylene (PEX-AL-PEX) Tubing
$29.00 $58.00
Standard Test Method for Determining Micropore Volume and Zeolite Area of a Catalyst
$30.00 $60.00
