• ASTM D6616-01a

ASTM D6616-01a

Standard Test Method for Measuring Viscosity at High Shear Rate by Tapered Bearing Simulator Viscometer At 100 oC

ASTM International, 11/10/2001

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:10/11/2001

Pages:13

File Size:1 file , 420 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the laboratory determination of the viscosity of engine oils at 100°C and 1·106s -1 using the Tapered Bearing Simulator (TBS) viscometer.

Note 1 - This test method is similar to Test Method D 4683 which uses the same TBS viscometer to measure high shear viscosity at 150°C.

1.2 The Newtonian calibration oils used to establish this test method range from approximately 5 to 12 mPa·s (cP) at 100°C and either the manual or automated protocol was used by each participant in developing the precision statement. The viscosity range of the test method at this temperature is from 1 mPa·s (cP) to above 25 mPa·s (cP, depending on the model of TBS.

1.3 The non-Newtonian reference oil used to establish the shear rate of 1·106s-1 for this test method has a viscosity of approximately 10 mPa·s at 100°C.

1.4 Application to petroleum products other than engine oil has not been determined in preparing the viscometric information for this test method.

1.5 This test method uses the milliPascal second (mPa·s) as the unit of viscosity. This unit is equivalent to the centiPoise (cP), which is shown in parentheses.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM Section 5:2011

ASTM Section 5:2011

ASTM Book of Standards - Section 5 - Petroleum Products, Lubricants, and Fossil Fuels (Vols 05.01-05.06)

$142.00 $285.41

ASTM B276-91(2000)

ASTM B276-91(2000)

Standard Test Method for Apparent Porosity in Cemented Carbides

$30.00 $60.00

ASTM C443-11

ASTM C443-11

Standard Specification for Joints for Concrete Pipe and Manholes, Using Rubber Gaskets

$26.00 $52.00

ASTM C660-81(2015)

ASTM C660-81(2015)

Standard Practices for Production and Preparation of Gray Iron Castings for Porcelain Enameling

$27.00 $54.00