Your shopping cart is empty!
ASTM International, 10/15/2008
Publisher: ASTM
File Format: PDF
$47.00$94.00
Published:15/10/2008
Pages:55
File Size:1 file , 1.3 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers and is required to evaluate the performance of engine oils intended to satisfy certain American Petroleum Institute (API) C service categories (included in Specification D 4485). It is performed in a laboratory using a standardized high-speed, single-cylinder diesel engine. Piston and ring groove deposit-forming tendency and oil consumption is measured. The piston, the rings, and the liner are also examined for distress and the rings for mobility.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Being an engine test method, this standard does have definite hazards that require safe practices (see Appendix X2 on Safety).
1.4 The following is the Table of Contents:
ASTM Book of Standards Section 13 (Volumes 13.01 and 13.02): Medical Devices and Services
$149.00 $299.19
Standard Test Method for Determining the Resistance of Paint Films and Related Coatings to Algal Defacement
$26.00 $52.00
Standard Test Method for Measuring the Curved Beam Strength of a Fiber-Reinforced Polymer-Matrix Composite
$32.00 $64.00
Standard Test Method for Rubber Shaft Seals Determination of Recovery From Bending
$30.00 $60.00
