• ASTM D6728-01

ASTM D6728-01

Standard Test Method for Determination of Contaminants in Gas Turbine and Diesel Engine Fuel by Rotating Disc Electrode Atomic Emission Spectrometry

ASTM International, 11/10/2001

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:10/11/2001

Pages:7

File Size:1 file , 90 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of contaminants and materials as a result of corrosion in gas turbine or diesel engine fuels by rotating disc electrode atomic emission spectroscopy (RDE-AES).

1.1.1 The test method is applicable to ASTM Grades 0-GT, 1-GT, 2-GT, 3-GT and 4-GT gas turbine fuels and Grades Low Sulfur No. 1-D, Low Sulfur No. 2-D, No. 1-D, No. 2-D and No. 4-D diesel fuel oils.

1.1.2 This test method provides a rapid at-site determination of contamination and corrosive elements ranging from fractions of mg/kg to hundreds of mg/kg in gas turbine and diesel engine fuels so the fuel quality and level of required treatment can be determined.

1.1.3 This test method uses oil-soluble metals for calibration and does not purport to quantitatively determine or detect insoluble particles.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. The preferred units are mg/kg (ppm by mass).

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM E1482-12(2017)

ASTM E1482-12(2017)

Standard Practice for Use of Gel Filtration Columns for Cytotoxicity Reduction and Neutralization

$30.00 $60.00

ASTM D93-18

ASTM D93-18

Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester

$38.00 $76.00

ASTM E1473-16

ASTM E1473-16

Standard Test Methods for Chemical Analysis of Nickel, Cobalt and High-Temperature Alloys

$49.00 $98.00

ASTM F1238-95(1999)

ASTM F1238-95(1999)

Standard Specification for Refractory Silicide Sputtering Targets for Microelectronic Applications

$25.00 $50.00