• ASTM D6750-05

ASTM D6750-05

Standard Test Methods for Evaluation of Engine Oils in a High-Speed, Single-Cylinder Diesel Engine-1K Procedure (0.4 % Fuel Sulfur) and 1N Procedure (0.04 % Fuel Sulfur)

ASTM International, 05/01/2005

Publisher: ASTM

File Format: PDF

$50.00$101.00


Published:01/05/2005

Pages:71

File Size:1 file , 1 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 These test methods cover the performance of engine oils intended for use in certain diesel engines. They are performed in a standardized high-speed, single-cylinder diesel engine by either the 1K (0.4 % fuel sulfur) or 1N (0.04 % fuel sulfur) procedure. The only difference in the two test methods is the fuel used. Piston and ring groove deposit-forming tendency and oil consumption are measured. Also, the piston, the rings, and the liner are examined for distress and the rings for mobility. These test methods are required to evaluate oils intended to satisfy API service categories CF-4 and CH-4 for 1K, and CG-4 for 1N of Specification D 4485.

1.2 These test methods, although based on the original Caterpillar 1K/1N procedures, also embody TMC information letters issued before these test methods were first published. These test methods are subject to frequent change. Until the next revision of these test methods, TMC will update changes in these test methods by the issuance of information letters which shall be obtained from TMC (see Annex A15).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therfore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.Specific precautionary statements appear throughout the text. Being engine tests, these test methods do have definite hazards that shall be met by safe practices (see Annex A16 on Safety Precautions).

More ASTM standard pdf

ASTM D7319-07

ASTM D7319-07

Standard Test Method for Determination of Total and Potential Sulfate and Inorganic Chloride in Fuel Ethanol by Direct Injection Suppressed Ion Chromatography

$29.00 $58.00

ASTM D287-92(2006)

ASTM D287-92(2006)

Standard Test Method for API Gravity of Crude Petroleum and Petroleum Products (Hydrometer Method)

$26.00 $52.00

ASTM D6837-06

ASTM D6837-06

Standard Test Method for Measurement of Effects of Automotive Engine Oils on Fuel Economy of Passenger Cars and Light-Duty Trucks in Sequence VIB Spark Ignition Engine

$47.00 $94.00

ASTM D1633-00(2007)

ASTM D1633-00(2007)

Standard Test Methods for Compressive Strength of Molded Soil-Cement Cylinders (Withdrawn 2016)

$26.00 $52.00