Your shopping cart is empty!
ASTM International, 01/01/2020
Publisher: ASTM
File Format: PDF
$34.00$69.00
Published:01/01/2020
Pages:11
File Size:1 file , 160 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This specification covers four grades of biodiesel (B100) for use as a blend component with middle distillate fuels. These grades are described as follows:
1.1.1 Grade No. 1-B S15-A special purpose biodiesel blendstock intended for use in middle distillate fuel applications which can be sensitive to the presence of partially reacted glycerides, including those applications requiring good low temperature operability, and also requiring a fuel blend component with 15 ppm sulfur (maximum).
1.1.2 Grade No. 1-B S500-A special purpose biodiesel blendstock intended for use in middle distillate fuel applications which can be sensitive to the presence of partially reacted glycerides, including those applications requiring good low temperature operability, and also requiring a fuel blend component with 500 ppm sulfur (maximum).
1.1.3 Grade No. 2-B S15-A general purpose biodiesel blendstock intended for use in middle distillate fuel applications that require a fuel blend component with 15 ppm sulfur (maximum).
1.1.4 Grade No. 2-B S500-A general purpose biodiesel blendstock intended for use in middle distillate fuel applications that require a fuel blend component with 500 ppm sulfur (maximum).
1.2 This specification prescribes the required properties of diesel fuels at the time and place of delivery. The specification requirements may be applied at other points in the production and distribution system when provided by agreement between the purchaser and the supplier.
1.3 Nothing in this specification shall preclude observance of federal, state, or local regulations which may be more restrictive.
Note 1: The generation and dissipation of static electricity can create problems in the handling of distillate fuel oils with which biodiesel may be blended. For more information on the subject, see Guide D4865.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Methods for Rubber - ;Determination of Metal Content by Flame Atomic Absorption (AAS) Analysis
$30.00 $60.00
Standard Test Method for In Situ Stress and Modulus of Deformation Using the Flatjack Method
Standard Test Method for Low-Level Iodine-131 in Water
Standard Specification for Asphalt Roof Coatings -- Asbestos-Free
$26.00 $52.00
