Your shopping cart is empty!
ASTM International, 12/01/2020
Publisher: ASTM
File Format: PDF
$31.00$62.00
Published:01/12/2020
Pages:6
File Size:1 file , 140 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method covers the determination of the pore size distribution of geotextile filters with pore sizes ranging from 1 to 1000 ''m.
Note 1:''The accuracy of this procedure has been verified up to a maximum pore size of 500 ''m. Above this value, accuracy has been found to be equipment dependent and should be verified by the user through checks on materials with known opening sizes.
1.2''The test method measures the entire pore size distribution in terms of a surface analysis of specified pore sizes in a geotextile, defined in terms of the limiting diameters.
1.3''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Bulk Density of Granular Refractory Materials
$28.00 $56.00
Standard Guide for Design and Installation of Plastic Siphonic Roof Drainage Systems
$24.00 $48.00
Standard Test Method for Calibration Verification of Laser Diffraction Particle Sizing Instruments Using Photomask Reticles
$30.00 $60.00
Standard Practices for Simulating Vehicular Response to Longitudinal Profiles of Traveled Surfaces
$28.00 $57.00