• ASTM D6780-05

ASTM D6780-05

Standard Test Method for Water Content and Density of Soil in Place by Time Domain Reflectometry (TDR)

ASTM International, 05/01/2005

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/05/2005

Pages:13

File Size:1 file , 320 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method may be used to determine the water content of soils and the in-place density of soils using a TDR apparatus.

1.2 This test method applies to soils that have 30 % or less by weight of their particles retained on the 19.0-mm ( 3/4-in.) sieve.

1.3 This test method is suitable for use as a means of acceptance for compacted fill or embankments.

1.4 This test method may not be suitable for organic and highly plastic soils.

1.5 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.

1.5.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.

1.6 Two alternative procedures are provided.

1.6.1 Procedure A involves two tests in the field, an in-place test and a test in a mold containing material excavated from the in-place test location. The apparent dielectric constant is determined in both tests.

1.6.2 Procedure B involves only an in-place test by incorporating a bulk electrical conductivity in addition to the apparent dielectric constant.

1.7 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. For additional information consult ASTM SI 10

1,8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM standard pdf

ASTM F1865-09

ASTM F1865-09

Standard Specification for Mechanical Cold Expansion Insert Fitting With Compression Sleeve for Cross-linked Polyethylene (PEX) Tubing (Withdrawn 2018)

$29.00 $58.00

ASTM D1139/D1139M-09

ASTM D1139/D1139M-09

Standard Specification for Aggregate for Single or Multiple Bituminous Surface Treatments

$26.00 $52.00

ASTM F533-02a

ASTM F533-02a

Standard Test Method for Thickness and Thickness Variation of Silicon Wafers (Withdrawn 2003)

$25.00 $51.60

ASTM F1533-01(2009)

ASTM F1533-01(2009)

Standard Specification for Deformed Polyethylene (PE) Liner (Withdrawn 2018)

$26.00 $52.00