Your shopping cart is empty!
ASTM International, 12/01/2018
Publisher: ASTM
File Format: PDF
$27.00$54.00
Published:01/12/2018
Pages:11
File Size:1 file , 150 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method specifies a method for the determination of the time-weighted average mass concentration of hexavalent chromium in workplace air samples.
1.2 This test method is applicable to the personal sampling of the inhalable fraction of airborne particles, as defined in ISO 7708, and to area (static) sampling.
1.3 The sample dissolution procedure specifies separate procedures for soluble and insoluble hexavalent chromium.
1.4 This test method is applicable to the determination of masses of 0.01 μg to 10 μg of hexavalent chromium per sample without dilution.
1.5 The concentration range for hexavalent chromium in air for which this procedure is applicable is approximately 0.1 μg/m³ to 100 μg/m³, assuming 1 m³ of air sample. The range can be extended upwards by appropriate dilution.
1.6 Interconversion of trivalent and hexavalent chromium species may occur during sampling and sample preparation, but these processes are minimized to the extent possible by the sampling and sample preparation procedures employed.
1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Apparent Density of Free-Flowing Metal Powders Using the Hall Flowmeter Funnel
$23.00 $46.00
Standard Specification for Aviation Turbine Fuels
$43.00 $86.00
Standard Specification for Seamless and Welded Ferritic/Austenitic Stainless Steel Pipe
$32.00 $64.00
Standard Test Method for Impact Strength of Adhesive Bonds
$22.00 $44.00