• ASTM D6873/D6873M-17

ASTM D6873/D6873M-17

Standard Practice for Bearing Fatigue Response of Polymer Matrix Composite Laminates

ASTM International, 04/01/2017

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/04/2017

Pages:10

File Size:1 file , 240 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice provides instructions for modifying static bearing test methods to determine the fatigue behavior of composite materials subjected to cyclic bearing forces. The composite material forms are limited to continuous-fiber reinforced polymer matrix composites in which the laminate is both symmetric and balanced with respect to the test direction. The range of acceptable test laminates and thicknesses are described in 8.2.

1.2 This practice supplements Test Method D5961/D5961M with provisions for testing specimens under cyclic loading. Several important test specimen parameters (for example, fastener selection, fastener installation method, and fatigue force/stress ratio) are not mandated by this practice; however, repeatable results require that these parameters be specified and reported.

1.3 This practice is limited to test specimens subjected to constant amplitude uniaxial loading, where the machine is controlled so that the test specimen is subjected to repetitive constant amplitude force (stress) cycles. Either engineering stress or applied force may be used as a constant amplitude fatigue variable. The repetitive loadings may be tensile, compressive, or reversed, depending upon the test specimen and procedure utilized.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4.1 Within the text the inch-pound units are shown in brackets.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E1191-03a

ASTM E1191-03a

Standard Guide for Conducting Life-Cycle Toxicity Tests with Saltwater Mysids

$32.00 $65.00

ASTM G61-86(2003)e1

ASTM G61-86(2003)e1

Standard Test Method for Conducting Cyclic Potentiodynamic Polarization Measurements for Localized Corrosion Susceptibility of Iron-, Nickel-, or Cobalt-Based Alloys

$29.00 $58.00

ASTM E1023-84(2002)

ASTM E1023-84(2002)

Standard Guide for Assessing the Hazard of a Material to Aquatic Organisms and Their Uses

$32.00 $65.00

ASTM MIL17V1-02

ASTM MIL17V1-02

MIL17, VOLUME 1: Polymer Matrix Composites: Guidelines For Characterization Of Structural Materials

$113.00 $226.06