• ASTM D6875-18

ASTM D6875-18

Standard Test Method for Solidification Point of Industrial Organic Chemicals by Thermistor

ASTM International, 01/01/2018

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/01/2018

Pages:4

File Size:1 file , 120 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers a general procedure for determining the solidification point of most organic chemicals having appreciable heats of fusion and solidification points between 4 and 41°C.

Note 1: Other test methods for determining freeze point and solidification point of aromatic hydrocarbons include Test Methods D852, D1015, D1016, D3799, D4493, and D6269.

1.2 This test method is applicable to relatively pure compounds only. Solidification point depression is dependent on impurity concentrations.

1.3 The following applies to all specified limits in this test method: for purposes of determining conformance with applicable specifications using this test method, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right hand digit used in expressing the specification limit, in accordance with the “rounding-off method” of Practice E29.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 8, Hazards.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM C1090/C1090M-15

ASTM C1090/C1090M-15

Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout

$34.00 $68.00

ASTM D97-17a

ASTM D97-17a

Standard Test Method for Pour Point of Petroleum Products

$30.00 $60.00

ASTM D3278-21

ASTM D3278-21

Standard Test Methods for Flash Point of Liquids by Small Scale Closed-Cup Apparatus

$29.00 $58.00

ASTM D4175-15c

ASTM D4175-15c

Standard Terminology Relating to Petroleum, Petroleum Products, and Lubricants

$52.00 $104.00