Your shopping cart is empty!
ASTM International, 05/01/2014
Publisher: ASTM
File Format: PDF
$50.00$101.00
Published:01/05/2014
Pages:64
File Size:1 file , 1.1 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers stressing an engine oil under modern high-speed diesel operating conditions and measures the oil's deposit control, lubrication ability, and resistance to oil consumption. It is performed in a laboratory using a standardized high-speed, single-cylinder diesel engine.4
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exceptions-Where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, and tubing size, or where a sole source supplier is specified.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. Being an engine test method, this test method does have definite hazards that require safe practices (see Appendix X2 on Safety).
1.4 The following is the Table of Contents:
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus and Installation
6
Intake Air System
6.2.1
Exhaust System
6.2.2
Fuel System
6.2.3
Oil Consumption System
6.2.4
Engine Oil System
6.2.5
Engine Coolant System
6.2.6
Engine Instrumentation
6.2.7
Reagents and Materials
7
Oil Samples
8
Preparation of Apparatus
9
General Engine Assembly Practices
9.1
Complete Engine Inspection
9.2
Copper Component
9.3
Engine Lubricant System Flush
9.4
Engine Piston Cooling Jet
9.5
Engine Measurements and Inspections
9.6
Cylinder Head
9.7
Valve Guide Bushings
9.8
Fuel Injector
9.9
Piston and Rings
9.10
Cylinder Liner
9.11
Compression Ratio
9.12
Engine Timing
9.13
Engine Coolant System Cleaning Procedure
9.14
Calibration and Standardization
10
Test Cell Instrumentation
10.1
Instrumentation Standards
10.2
Coolant Flow
10.3
Fuel Injectors
10.4
Air Flow
Standard Consumer Safety Specification for Baby Changing Products for Domestic Use
$36.00 $72.00
Standard Test Methods for Rubber Cements
$34.00 $68.00
Standard Test Methods for Laboratory Determination of Density (Unit Weight) of Soil Specimens
$29.00 $58.00
Standard Specification for Lathing and Furring Accessories, and Fasteners, for Interior and Exterior Portland Cement-Based Plaster
