• ASTM D7016/D7016M-18

ASTM D7016/D7016M-18

Standard Test Method to Evaluate Edge Binding Components Used in Mattresses After Exposure to An Open Flame

ASTM International, 08/01/2018

Publisher: ASTM

File Format: PDF

$33.00$67.00


Published:01/08/2018

Pages:11

File Size:1 file , 490 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method measures the flammability characteristics of mattress edge bindings and sewing threads during and after exposure to an open flame ignition source.

1.1.1 This test method is used to evaluate these components either independently or in combination for use in mattresses designed with a fire barrier fabric.

1.1.1.1 The test method is used to evaluate mattress edge binding and sewing thread when the design requires the use of these components.

1.1.2 This test method can be used as a screening test method to determine how sewing thread and mattress edge binding component combinations will perform.

1.2 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.3 Fire testing of products and materials is inherently hazardous, and adequate safeguards for personnel and property shall be employed in conducting these tests.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM D3948-05

ASTM D3948-05

Standard Test Method for Determining Water Separation Characteristics of Aviation Turbine Fuels by Portable Separometer

$33.00 $67.00

ASTM E515-05

ASTM E515-05

Standard Test Method for Leaks Using Bubble Emission Techniques

$26.00 $52.00

ASTM C92-95(2005)

ASTM C92-95(2005)

Standard Test Methods for Sieve Analysis and Water Content of Refractory Materials

$26.00 $52.00

ASTM F1446-05

ASTM F1446-05

Standard Test Methods for Equipment and Procedures Used in Evaluating the Performance Characteristics of Protective Headgear

$34.00 $69.00