Your shopping cart is empty!
ASTM International, 04/15/2012
Publisher: ASTM
File Format: PDF
$30.00$60.00
Published:15/04/2012
Pages:9
File Size:1 file , 160 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers and specifies a procedure for the concurrent measurement of both the dynamic viscosity, n, and the density, p, of liquid petroleum products and crude oils, both transparent and opaque. The kinematic viscosity, v, can be obtained by dividing the dynamic viscosity, n, by the density, p, obtained at the same test temperature.
1.2 The result obtained from this test method is dependent upon the behavior of the sample and is intended for application to liquids for which primarily the shear stress and shear rate are proportional (Newtonian flow behavior).
1.3 The precision has only been determined for those materials, viscosity ranges, density ranges, and temperatures as indicated in Section 15 on Precision and Bias. The test method can be applied to a wider range of materials, viscosity, density, and temperature. For materials not listed in Section 15 on Precision and Bias, the precision and bias may not be applicable.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
Standard Practice for Sampling of Geosynthetics for Testing
$26.00 $52.00
Standard Specification for Steel, Sheet, Carbon, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for
$43.00 $86.00
Standard Test Method for Volatile Matter Content of Activated Carbon Samples
Standard Specification for Steel Sheet, Zinc Coated by the Electrolytic Process for Applications Requiring Designation of the Coating Mass on Each Surface
