• ASTM D7109-04

ASTM D7109-04

Standard Test Method for Shear Stability of Polymer Containing Fluids Using a European Diesel Injector Apparatus at 30 and 90 Cycles

ASTM International, 12/01/2004

Publisher: ASTM

File Format: PDF

$29.00$58.00


Published:01/12/2004

Pages:9

File Size:1 file , 150 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the evaluation of the shear stability of polymer-containing fluids. The test method measures the viscosity loss, in mm²/s and percent, at 100C of polymer-containing fluids when evaluated by a diesel injector apparatus procedure that uses European diesel injector test equipment. The viscosity loss reflects polymer degradation due to shear at the nozzle. Viscosity loss is evaluated after both 30 and 90 cycles of shearing.

Note 1

This test method evaluates the shear stability of oils after both 30 and 90 cycles of shearing. In general, there is no correlation between results after 30 cycles and results after 90 cycles of shearing.

Note 2

Test Method D 6278 uses essentially the same procedure with 30 cycles only instead of both 30 and 90 cycles. The correlation between results from this test method at 30 cycles and results from Test Method D 6278 has not been established.

Note 3

Test Method D 2603 has been used for similar evaluation of shear stability; limitations are as indicated in the significance statement. No detailed attempt has been undertaken to correlate the results of this test method with those of the sonic shear test method.

Note 4

This test method uses test apparatus as defined in CEC L-14-A-93. This test method differs from CEC-L-14-A-93 in the period of time required for calibration.

Note 5

Test Method D 5275 also shears oils in a diesel injector apparatus but may give different results.

Note 6

This test method has different calibration and operational requirements than Test Method D 3945.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section .

More ASTM standard pdf

ASTM E2313-15

ASTM E2313-15

Standard Test Method for Aldehydes in Mono-, Di-, and Triethylene Glycol (using Spectrophotometry)

$31.00 $62.00

ASTM E201-96

ASTM E201-96

Test Method for Calculation of Volume and Weight of Industrial Chemical Liquids (Withdrawn 2001)

$32.00 $65.00

ASTM E2073-10

ASTM E2073-10

Standard Test Method for Photopic Luminance of Photoluminescent (Phosphorescent) Markings (Withdrawn 2019)

$29.00 $58.00

ASTM F1076-87(2010)

ASTM F1076-87(2010)

Standard Practice for Expanded Welded and Silver Brazed Socket Joints for Pipe and Tube

$29.00 $58.00