• ASTM D7173-20

ASTM D7173-20

Standard Practice for Determining the Separation Tendency of Polymer from Polymer-Modified Asphalt

ASTM International, 05/01/2020

Publisher: ASTM

File Format: PDF

$22.00$44.00


Published:01/05/2020

Pages:2

File Size:1 file , 60 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This practice describes a laboratory procedure for determining the tendency of polymer to separate from polymer-modified asphalt under static heated storage conditions. The results of testing on material prepared according to this practice may be used as a guideline when formulating products or to establish field handling procedures. Large differences in test results between top and bottom specimens indicate that there is a degree of incompatibility between the polymer and the base asphalt.

1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E74-18e1

ASTM E74-18e1

Standard Practices for Calibration and Verification for Force-Measuring Instruments

$29.00 $58.00

ASTM B699-86(2021)e1

ASTM B699-86(2021)e1

Standard Specification for Coatings of Cadmium Vacuum-Deposited on Iron and Steel

$26.00 $52.00

ASTM F1387-23

ASTM F1387-23

Standard Specification for Performance of Piping and Tubing Mechanically Attached Fittings

$41.00 $82.00

ASTM F1496-13(2019)

ASTM F1496-13(2019)

Standard Test Method for Performance of Convection Ovens

$27.00 $54.00