• ASTM D7184-15(2019)e1

ASTM D7184-15(2019)e1

Standard Test Method for Ultra Low Nitrogen in Aromatic Hydrocarbons by Oxidative Combustion and Reduced Pressure Chemiluminescence Detection

ASTM International, 06/01/2019

Publisher: ASTM

File Format: PDF

$30.00$60.00


Published:01/06/2019

Pages:6

File Size:1 file , 87 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers the determination of total nitrogen in aromatic hydrocarbons, such as benzene, toluene, and xylene.

1.2 This test method is applicable for samples containing nitrogen from 0.1 to 1.2 mg N/kg. For higher nitrogen concentrations refer to Test Method D4629. With careful analytical technique, this method can be used to successfully analyze concentrations below the current scope (see Appendix X1).

1.3 In determining the conformance of the test results using this method to applicable specifications; results shall be rounded off in accordance with the rounding-off method of Practice E29.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 9.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM E878-01(2005)

ASTM E878-01(2005)

Standard Test Method for Determination of Titanium in Iron Ores and Related Materials by Diantipyrylmethane Ultraviolet Spectrometry

$26.00 $52.00

ASTM A227/A227M-99(2005)

ASTM A227/A227M-99(2005)

Standard Specification for Steel Wire, Cold-Drawn for Mechanical Springs

$26.00 $52.00

ASTM D1962-85(1989)e1

ASTM D1962-85(1989)e1

Standard Test Method for Saponification Value of Drying Oils, Fatty Acids, and Polymerized Fatty Acids

$126.00 $253.25

ASTM A1064/A1064M-16

ASTM A1064/A1064M-16

Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete

$32.00 $65.00