• ASTM D7220-12(2017)

ASTM D7220-12(2017)

Standard Test Method for Sulfur in Automotive, Heating, and Jet Fuels by Monochromatic Energy Dispersive X-ray Fluorescence Spectrometry

ASTM International, 05/01/2017

Publisher: ASTM

File Format: PDF

$34.00$68.00


Published:01/05/2017

Pages:7

File Size:1 file , 100 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method specifies an energy-dispersive X-ray fluorescence (EDXRF) method for the determination of total sulfur in automotive, No. 2 heating, and jet fuels with a concentration range of 3 mg/kg to 942 mg/kg.

1.1.1 The pooled limit of quantitation of this test method as obtained by statistical analysis of inter laboratory test results is 3 mg/kg sulfur.

1.1.2 This test method is applicable to gasoline, oxygen enriched gasoline (RFG), diesel, diesel/biodiesel blends containing up to twenty volume percent biodiesel, kerosene, jet fuel, jet fuel/biodiesel blends containing up to five volume percent biodiesel and No. 2 home heating oil.

1.2 A fundamental assumption in this test method is that the standard and sample matrix is well matched. Matrix mismatch can be caused by C/H ratio differences between samples and standards or by the presence of other heteroatoms.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3.1 The preferred concentration units are mg/kg sulfur.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F1026-86(1996)

ASTM F1026-86(1996)

Standard Specification for General Workmanship and Performance Measurements of Hemostatic Forceps

$25.00 $50.00

ASTM C876-15

ASTM C876-15

Standard Test Method for Corrosion Potentials of Uncoated Reinforcing Steel in Concrete

$32.00 $64.00

ASTM D5900-15c

ASTM D5900-15c

Standard Specification for Physical and Chemical Properties of Industry Reference Materials (IRM)

$29.00 $58.00

ASTM E1084-86(2003)

ASTM E1084-86(2003)

Standard Test Method for Solar Transmittance (Terrestrial) of Sheet Materials Using Sunlight

$29.00 $58.00