• ASTM D7242/D7242M-06(2013)e1

ASTM D7242/D7242M-06(2013)e1

Standard Practice for Field Pneumatic Slug (Instantaneous Change in Head) Tests to Determine Hydraulic Properties of Aquifers with Direct Push Groundwater Samplers (Withdrawn 2022)

ASTM International, 12/01/2013

Publisher: ASTM

File Format: PDF

$36.00$72.00


Published:01/12/2013

Pages:14

File Size:1 file , 350 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This standard practice covers the field methods used to conduct an instantaneous change in head (slug) test when pneumatic pressure is used to initiate the change in head pressure within the well or piezometer. While this practice specifically addresses use of pneumatic initiation of slug tests with direct push tools these procedures may be applied to wells or piezometers installed with rotary drilling methods when appropriate.

1.2 This standard practice is used to obtain the required field data for determining hydraulic properties of an aquifer or a specified vertical interval of an aquifer. Field data obtained from application of this practice are modeled with appropriate analytical procedures (Test Methods D4104, D5785, D5881, D5912, Ref (1)2).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 This practice offers a set of instructions for performing one or more specific operations. This document cannot replace education or experience and should be used in conjunction with professional judgment. Not all aspects of this practice may be applicable in all circumstances. This ASTM standard is not intended to represent or replace the standard of care by which the adequacy of a given professional service must be judged, nor should this document be applied without consideration of a project's many unique aspects. The word “standard” in the title means that the document has been approved through the ASTM consensus process.

More ASTM standard pdf

ASTM F2473-12(2023)

ASTM F2473-12(2023)

Standard Test Method for Performance of Water-Bath Rethermalizers

$31.00 $63.00

ASTM C216-23

ASTM C216-23

Standard Specification for Facing Brick (Solid Masonry Units Made from Clay or Shale)

$31.00 $63.00

ASTM F2195-18(2023)

ASTM F2195-18(2023)

Standard Specification for Linoleum Floor Tile

$25.00 $50.00

ASTM F2547-18(2023)

ASTM F2547-18(2023)

Standard Test Method for Determining the Attenuation Properties in a Primary X-ray Beam of Materials Used to Protect Against Radiation Generated During the Use of X-ray Equipment

$25.00 $50.00