Your shopping cart is empty!
ASTM International, 07/01/2021
Publisher: ASTM
File Format: PDF
$23.00$46.00
Published:01/07/2021
Pages:4
File Size:1 file , 210 KB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''These test methods cover the procedure for sampling and testing the strength of laps formed with adhesive used with polymer-modified bituminous sheet materials.
1.2''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Practice for Damage Resistance Testing of Sandwich Constructions
$29.00 $58.00
Standard Specification for Alloy-Steel and Stainless Steel Bolting Materials for Low-Temperature Service
$30.00 $60.00
Standard Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings
$26.00 $52.00
Standard Specification for Rubber Insulating Sheeting