• ASTM D7422-08

ASTM D7422-08

Standard Test Method for Evaluation of Diesel Engine Oils in T-12 Exhaust Gas Recirculation Diesel Engine

ASTM International, 05/01/2008

Publisher: ASTM

File Format: PDF

$41.00$83.00


Published:01/05/2008

Pages:34

File Size:1 file , 1.6 MB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including lead corrosion and wear of piston rings and cylinder liners in an engine equipped with exhaust gas recirculation and running on ultra-low sulfur diesel fuel. This test method is commonly referred to as the Mack T-12.

1.2 The values stated in either SI units, inch-pound units, or other units are to be regarded separately as the primary units.

1.2.1 For each parameter, the primary units are shown first. Secondary units may be shown in parentheses, for information purposes only. These secondary units may or may not be exact equivalents to the primary units.

1.2.2 SI units are provided for all parameters except where there is no direct equivalent such as the units for screw threads, national pipe threads/diameters, and tubing size.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Annex A6 for specific safety precautions.

More ASTM standard pdf

ASTM D5104-96

ASTM D5104-96

Standard Test Method for Shrinkage of Textile Fibers (Single-Fiber Test)

$25.00 $50.00

ASTM F475-77(1998)

ASTM F475-77(1998)

Standard Specification for Test Screw Used in Screw-Retention Test of Binding Mounting Area on Alpine Skis (Withdrawn 2004)

$25.00 $50.00

ASTM C500-98(2002)

ASTM C500-98(2002)

Standard Test Methods for Asbestos-Cement Pipe

$30.00 $60.00

ASTM D2992-96e1

ASTM D2992-96e1

Standard Practice for Obtaining Hydrostatic or Pressure Design Basis for "Fiberglass" (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings

$32.00 $65.00