Your shopping cart is empty!
ASTM International, 04/01/2015
Publisher: ASTM
File Format: PDF
$41.00$83.00
Published:01/04/2015
Pages:38
File Size:1 file , 1.7 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including lead corrosion and wear of piston rings and cylinder liners in an engine equipped with exhaust gas recirculation and running on ultra-low sulfur diesel fuel.2 This test method is commonly referred to as the Mack T-12.
1.1.1 This test method also provides the procedure for running an abbreviated length test, which is commonly referred to as the T-12A. The procedures for the T-12 and T-12A are identical with the exception of the items specifically listed in Annex A9. Additionally, the procedure modifications listed in Annex A9 refer to the corresponding section of the T-12 procedure.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exception-Where there is no direct SI equivalent, such as the units for screw threads, National Pipe Threads/diameters, tubing size, and single source supply equipment specifications.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Annex A6 for specific safety precautions.
Standard Test Method for Evaluating Automotive Spark-Ignition Engine Fuel for Electronic Port Fuel Injector Fouling by Bench Procedure
$29.00 $58.00
Standard Test Method for Measuring the Time Dependent Modulus of Sealants Using Stress Relaxation
$25.00 $50.00
Standard Specification for Hollow Brick (Hollow Masonry Units Made From Clay or Shale)
$30.00 $60.00
Standard Specification for Fiber-Reinforced Concrete and Shotcrete
