Your shopping cart is empty!
ASTM International, 04/01/2022
Publisher: ASTM
File Format: PDF
$39.00$78.00
Published:01/04/2022
Pages:39
File Size:1 file , 1.7 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1''This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including lead corrosion and wear of piston rings and cylinder liners in an engine equipped with exhaust gas recirculation and running on ultra-low sulfur diesel fuel.2 This test method is commonly referred to as the Mack T-12.
1.1.1''This test method also provides the procedure for running an abbreviated length test, which is commonly referred to as the T-12A. The procedures for the T-12 and T-12A are identical with the exception of the items specifically listed in Annex A9. Additionally, the procedure modifications listed in Annex A9 refer to the corresponding section of the T-12 procedure.
1.2''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1''Exception'''Where there is no direct SI equivalent, such as the units for screw threads, National Pipe Threads/diameters, tubing size, and single source supply equipment specifications.
1.3''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Annex A6 for specific safety precautions.
1.4''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Butt Heat Fusion Polyethylene (PE) Plastic Fittings for Polyethylene (PE) Plastic Pipe and Tubing
$30.00 $60.00
Standard Specification for Zinc-Coated Steel Structural Wire Rope
Standard Test Method for Determining Filterability of Aviation Turbine Fuel
Standard Specification for Hardware Cloth (Woven or Welded Galvanized Steel Wire Fabric)
$26.00 $52.00
