Your shopping cart is empty!
ASTM International, 10/01/2016
Publisher: ASTM
File Format: PDF
$41.00$83.00
Published:01/10/2016
Pages:27
File Size:1 file , 1.1 MB
Note:This product is unavailable in Russia, Ukraine, Belarus
1.1 This test method, commonly referred to as the Cummins ISB Test, covers the utilization of a modern, 5.9 L, diesel engine equipped with exhaust gas recirculation and is used to evaluate oil performance with regard to valve-train wear.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.2.1 Exceptions-SI units are provided for all parameters except where there is no direct equivalent such as the units for screw threads, National Pipe Threads/diameters, tubing size, or where there is a sole source of supply equipment specification.
1.2.2 See also A8.1 for clarification; it does not supersede 1.2 and 1.2.1.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Annex A1 for general safety precautions.
1.4 Table of Contents:
Section
Scope
1
Referenced Documents
2
Terminology
3
Summary of Test Method
4
Significance and Use
5
Apparatus
6
Engine Fluids and Cleaning Solvents
7
Preparation of Apparatus
8
Engine/Stand Calibration and Non-Reference Oil Tests
9
Test Procedure
10
Calculations, Ratings, and Test Validity
11
Report
12
Precision and Bias
13
Annexes
Safety Precautions
Annex A1
Intake Air Aftercooler
Annex A2
The Cummins ISB Engine Build Parts Kit
Annex A3
Sensor Locations and Special Hardware
Annex A4
External Oil System
Annex A5
Fuel Specification
Annex A6
Cummins Service Publications
Annex A7
Specified Units and Formats
Annex A8
Oil Analyses
Annex A9
Standard Test Method for Preparation and Elemental Analysis of Liquid Hazardous Waste by Energy-Dispersive X-Ray Fluorescence
$30.00 $60.00
Standard Test Method for Pumpability of Industrial Fuel Oils (Withdrawn 2010)
$26.00 $52.00
Standard Practices for the Measurement of Radioactivity
$43.00 $86.00
Standard Test Method for Seal Quality of Anodic Coatings on Aluminum by Acid Dissolution
