• ASTM D7518-20

ASTM D7518-20

Standard Specification for 1,3 Propanediol (PDO) Base Engine Coolant for Automobile and Light-Duty Service

ASTM International, 04/01/2020

Publisher: ASTM

File Format: PDF

$25.00$50.00


Published:01/04/2020

Pages:5

File Size:1 file , 100 KB

Note:This product is unavailable in Russia, Ukraine, Belarus

1.1 This specification covers the requirements for 1,3 propanediol base engine coolants used in automobiles or other light-duty service cooling systems. When concentrates are used at 40 % to 70 % concentration by volume in water, or when prediluted glycol base engine coolants (50 volume % minimum) are used without further dilution, they will function effectively to provide protection against freezing, boiling, and corrosion.

1.2 The coolants governed by this specification are categorized as follows:

Coolant Type

Description

 

 

I

1,3 Propanediol base concentrate

II

1,3 Propanediol predilute (50 vol %)

Note 1: This specification is based on the knowledge of the performance of engine coolants prepared from new or virgin ingredients.

Note 2: This specification applies to automobiles and light-duty service. A specification for heavy-duty engine service is under development.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

More ASTM standard pdf

ASTM F1000-95

ASTM F1000-95

Standard Practice for Piping System Drawing Symbols (Withdrawn 2004)

$45.00 $91.00

ASTM C1055-03(2014)

ASTM C1055-03(2014)

Standard Guide for Heated System Surface Conditions that Produce Contact Burn Injuries

$30.00 $60.00

ASTM F1598-95(2014)

ASTM F1598-95(2014)

Standard Test Method for Determining the Effects of Chemical/Solvent Exposure to a Membrane Switch/Graphic Overlay (Spot Test Method) (Withdrawn 2023)

$30.00 $60.00

ASTM E2594-09(2014)

ASTM E2594-09(2014)

Standard Test Method for Analysis of Nickel Alloys by Inductively Coupled Plasma Atomic Emission Spectrometry (Performance-Based Method)

$31.00 $62.00